D7800 model srrp $695.00 inc gst installed

This multi Australian Standards approved immobiliser alarm provides two circuits of engine immobilisation operated by rolling code random encrypted remote control, with inbuilt intelligent auto transponder disarm. Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via an intelligent soft tone control Australian Standards 120dB battery back up siren, visually via the vehicle indicators and via high intensity blue LED's dash and windscreen mounted. The system has status / diagnostic reporting and may provide keyless entry.

Operation
Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active.
Disarming procedure
The system will disarm when the main button of a valid remote control is pressed.
Auto Arming feature
The immobiliser will automatically immobilise the engine 39 seconds after the engine has stopped, if the vehicle is left untouched.


Convenience Functions
Panic / Car Finder
Press and hold second button of remote control to cause siren to sound and indicators to flash.
Courtesy light switch activation
System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed.
Electronic boot release (optional)
Press and hold the secondary remote control button to activate boot release output. The indicators will flash four time each time the boot release signal is sent.

Open door warning
Siren will chirp 8 times if door is open, and 6 times if bonnet is open; while system is being armed.
Full diagnostic report
Press and hold both buttons on a valid remote control to receive report of last three triggers.
Low remote battery warning
System will flash indicators twice when ignition is turned on to report remote control battery is low.

Immobilisation
Two independent circuits of immobilisation
30 Amp rated, normally open contacts.
Automatic immobilisation
39 seconds after ignition switch is turned off.
Safety circuitry in case of power failure
System sources alternate power from ignition if main power is lost.

Controllers
Two polycarbonate remote controls
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal.
Weather proof case
Both halves of the case are sealed by a silicon membrane.
Remote control with transponder enhancements
Allows the immobiliser to disarm automatically when ignition switch is turned on.
Large system memory
Allows system to track three controllers.
Controller re-programming
Service technician can delete lost or stolen controllers from memory.
Wiring
Security wiring
All cables extending from the module are black and same diameter.
Security housing
Connector plug is enclosed within module case to prevent access by thief.
Stealth wiring
Cutting any immobilisation wiring will still leave the car secure.
Override
Emergency Personal Identification Number override
Enter the secret four digits to override the immobiliser .
Alterable PIN
Users can change the numbers of their secret override PIN .
One shot override
Immobiliser always re-arms to protect vehicle, re-enter PIN if vehicle needs to be driven after auto-arming has occurred.
High security keys and lock
Disable siren sound when vehicle is taken in for service.
PIN card
Secret override PIN is supplied on handy 90mm x 50mm card.
Visual Output
Super bright blue dash LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window.
Super bright blue windscreen LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window.
Arm/Disarm confirmation
System flashes car indicators when arming or disarming.
Alarm illumination
System flashes car indicators when thief triggers alarm.
Trigger diagnostics
System will flash indicators to report the last triggered circuit.

Standards Compliance
Australian Standard for vehicle Immobilisers
AS/NZS 4601:1999.
Australian Standard for Intruder alarm systems - Road vehicles - Performance requirements
AS/NZS 3749.1:1997.
Australian Standard for Intruder alarm systems - Road vehicles - Performance requirements
AS/NZS 3749.1:2003 Class A.
Manufactured in ISO9001 facility
Built within world standard production facility.


Intrusion Detection
Doors, bonnet and boot monitoring
Triggers alarm system if intruder opens any protected entry point in vehicle .
Audio glass breakage detection
Uses the sound of the breaking glass to trigger (not vibration)
Accepts plug-in Ultra-sonic sensor
Sensor produces a 40KHz sound wave and measures echo to detect intruder,
Accepts plug-in single zone microwave sensor
Sensor produces a microwave field to detect intruder,
Accepts plug-in dual zone microwave sensor
Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full,
Accepts plug-in single stage shock sensor
Sensor measures vibration subjected to vehicle to detect intruder,
Accepts plug-in two stage shock sensor
Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full,
Compatible with tilt sensor
Sensor measures vehicle angle with respect to earth, triggers if angle changes - no response to vibration 

Optional extra Central Locking
Locks and unlocks all doors
System can trigger factory central locking, aftermarket central locking or central locking relays.
Variable pulse time
Extend pulse length to drive pneumatic central locking systems (Mercedes)
Automatic re-locking
System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed
Anti-hijacking protection
System locks doors when ignition is turned on, unlocks when ignition is turned off
Dual stage unlock
Allows user to unlock driver's door before unlocking all other doors.

Warranty
Manufacturers warranty on Control module
Guarantees control module is free from manufacturing defects for 36 months from time of purchase.
Manufacturers warranty on Sundry items
Guarantees remote controls, siren and sundry items are free from manufacturing defects for 12 months from time of purchase.